TM 5-3805-254-34
6-30. FORWARD CLUTCH REPAIR (Con’t).
NOTE
Perform step 14 only If collector ring is damaged.
14.
With input shaft (21) facing upward, support
collector ring (20) and press input shaft and
housing (7) assembly downward to remove
collector ring from housing.
b.
CLEANING AND INSPECTOR
WARNING
Dry cleaning solvent, PD680, Is toxic and flammable. Always wear protective goggles and gloves,
and use only In a well-ventilated area. Avoid contact with skin, eyes, and clothes, and DO NOT
breathe vapors. DO NOT use near open flame or excessive heat. The solvent’s flash point Is
100°F138°F (38°C59°C). If you become dizzy while using cleaning solvent, Immediately get fresh
air and medical help. If solvent contacts eyes, Immediately wash your eyes and get medical aid.
1. Clean metal parts, except clutch disks, with dry cleaning solvent.
2. Inspect metal parts for cracks, breaks, wear, or other damage. Replace if damaged.
3. Inspect bearing race, and bearing ring for wear or damage. Replace if damaged.
4. Inspect PTO gear for chipped or broken teeth. Replace if damaged.
5. Inspect for broken or deformed springs. Springs must meet following requirements:
(a)
Length without load:........................................................................1.25 in. (3.18 cm).
(b)
Length with load of 17.9-18.9 lb (79.6-84 N): ..............................0.88 in. (22.35 mm).
TA703849
6-132
