TM 5-3805-254-34
9-1. FORWARD-REAR DIFFERENTIAL MAINTENANCE (Con’t).
b. DIFFERENTIAL REMOVAL AND DISASSEMBLY I
1.
Mount differential carrier (2) in vise with soft
jaws.
2.
Cut lockwire (7) securing bolts (8) in bearing cap
(9). Discard lockwire.
3.
Mark bearing cap (9) and legs of differential
carrier (2) to ensure proper assembly and
installation.
4.
Remove two bolts (8) and bearing cap (9).
5.
Repeat steps 2 through 4 for other bearing cap
(9).
6.
Lift differential (11) out of differential carrier (2).
7.
Remove two bearing races (10) from legs of
differential carrier (2).
WARNING
Tightly hold no-spin differential together to contain spring pressure as differential case half is
removed. Failure to follow this warning may result in Injury to personnel or damage to differential
case assembly components.
NOTE
Bolt, two washers, and nut used In step 8 should be from shop stock and are used to hold no-spin
differential assembly together when differential case half is removed.
8.
Install bolt (12), two washers (13), and nut (15) through center of no-spin differential assembly (14). Tighten nut
fingertight.
9-3
