TM 5-3805-254-34
9-5.
REAR-REAR DIFFERENTIAL MAINTENANCE (Con’t).
7.
Coat ring gear set (61) teeth with Prussian blue
paste.
8.
Turn gear and pinion assembly (31) and ring
gear set (61). High contact indicates gear and
pinion assembly is too far out. Remove shims
(35) to move gear and pinion assembly in.
9.
Low contact indicates gear and pinion assembly
(31) is too deep. Add shims (35) to move gear
and pinion assembly out.
h.
DIFFERENTIAL ASSEMBLY AND INSTALLSTION
NOTE
If no-spin differential was disassembled, perform steps 1 through 4. If not, go to step 6.
1.
Install two drive gears (25), spring retainers (24), springs (23), and side gears (22) on spider (26) and install bolt
(12) and washer (13) through center.
TA703986
9-55
