TM 5-3805-254-34
12-3. RIGHT POWER STEERING GEAR REPAIR (Cont).
NOTE
Perform step 7 at each end of gear housing.
7.
Install new gasket (11) and cylinder head (12) on gear housing (1) with ten new lockwashers (14) and screws (13).
Torque to 20 lb.-ft. (27 N-m).
8.
Press gear (7) on output shaft (6).
9.
Install output shaft (6) in gear housing (1).
10.
Install gear retaining nut (8) on output shaft (6).
Tighten nut against gear (7), then loosen nut
until holes in nut and gear aline. Install two new
lockwashers (9) and capscrews (10).
11.
Install new preformed packing (2) on housing
cover (3) and install housing cover to gear
housing (1) with eight new lockwashers (5) and
screws (4). Torque screws to 83 lb.ft. (113
N.m).
TA704031
12-20