TM 5-3805-254-34
15-36.
DUMP BODY REPLACEMENT (Con’t).
WARNING
Ensure that all personnel are clear of dump body before lowering, to prevent Injury to personnel.
8.
Lower dump body to ground.
9.
Position wood block between hydraulic cylinder (6) and frame (8) crossmember to prevent hydraulic cylinder from
pivoting toward rear of truck.
b.
INSTALLATION
1.
Remove wood block from between hydraulic cylinder (6) and frame (8) crossmember.
WARNING
Ensure that all personnel are clear of dump body before raising to prevent Injury to personnel.
2.
Attach lifting device to dump body (2). Raise dump body vertically high enough to clear hydraulic cylinder (6).
3.
Position dump body (2) to frame (8).
4.
Install hinge bar (9) and two spacers (10) with two new cotter pins (11).
5.
Install cylinder pin (5) to top of hydraulic cylinder (6) to secure hydraulic cylinder to dump body (2).
6.
Remove overhead lifting device.
WARNING
Welding or cutting may produce fumes and gases hazardous to health. Avoid breathing these
fumes and gases.
7.
Using welding torch, weld two steel plates (7) to dump body (2) to cover each end of cylinder pin (5).
15-109
