TM 5-3805-264-13&P
0059
REMOVAL
WARNING
DO NOT disconnect hydraulic lines while engine is running. Engine must be shut down and
dump body fully lowered or supported on body props before lines are disconnected.
Escaping hydraulic fluid under pressure can penetrate the skin. Hydraulic oil is slippery and
may cause falls. A suitable container should be used to catch any draining hydraulic fluid.
Ensure that all spills are cleaned up immediately and disposed of in accordance with local
procedures. Failure to comply may result in personnel injury or death.
CAUTION
Hoses and ports in hydraulic components should be plugged to prevent contamination of
hydraulic system (WP 0072). Failure to comply may result in damage to equipment.
NOTE
1.
Loosen clamp (Figure 1, Item 11) and disconnect suction hose (Figure 1, Item 12) from adapter
(Figure 1, Item 13).
2.
Remove adapter (Figure 1, Item 13) from hydraulic pump (Figure 1, Item 5).
3.
Disconnect hose (Figure 1, Item 19) from adapter (Figure 1, Item 20). Disconnect hose (Figure 1, Item 18)
from adapter (Figure 1, Item 17).
4.
Remove adapters (Figure 1, Items 17 and 20) from control valve (Figure 1, Item 4).
5.
Disconnect hose (Figure 1, Item 15) from elbow (Figure 1, Item 16).
6.
Remove elbow (Figure 1, Item 16) from control valve (Figure 1, Item 4).
7.
Remove nut (Figure 1, Item 9) and washer (Figure 1, Item 8) from stud (Figure 1, Item 6) of hydraulic pump
(Figure 1, Item 5).
8.
Remove two screws (Figure 1, Item 10) and support bracket (Figure 1, Item 7) from transmission housing
(Figure 1, Item 14).
WARNING
Use extreme care when handling heavy parts. Lifting cables, chains, hooks, and slings
must be in good condition and of suitable capacity. Keep clear of parts supported only by
lifting device. Failure to comply may result in personnel injury, death, and/or damage to
equipment.
9.
Remove four nuts (Figure 1, Item 3), washers (Figure 1, Item 2), screws (Figure 1, Item 1), and hydraulic
pump (Figure 1, Item 5) from Power Take Off (PTO) (Figure 1, Item 21).
0059-2
03/15/2011Rel(1.10)root(maintwp)wpno(M1004826413)