TM 5-3805-264-13&P
0059
INSTALLATION
WARNING
Use extreme care when handling heavy parts. Lifting cables, chains, hooks, and slings
must be in good condition and of suitable capacity. Keep clear of parts supported only by
lifting device. Failure to comply may result in personnel injury, death, and/or damage to
equipment.
NOTE
Use antiseizing tape on all pipe threads (WP 0072).
1.
Install hydraulic pump (Figure 2, Item 5) on PTO (Figure 2, Item 21) with four screws (Figure 2, Item 1),
washers (Figure 2, Item 2), and nuts (Figure 2, Item 3).
2.
Install support bracket (Figure 2, Item 7) on transmission housing (Figure 2, Item 14) with two screws
(Figure 2, Item 10). Torque screws to 7080 lb-ft (95108 Nm).
3.
Install washer (Figure 2, Item 8) and nut (Figure 2, Item 9) on stud (Figure 2, Item 6) of hydraulic pump
(Figure 2, Item 5).
4.
Install elbow (Figure 2, Item 16) on control valve (Figure 2, Item 4).
5.
Connect hose (Figure 2, Item 15) to elbow (Figure 2, Item 16).
6.
Install adapters (Figure 2, Items 17 and 20) on control valve (Figure 2, Item 4).
7.
Connect hoses (Figure 2, Items 18 and 19) on adapters (Figure 2, Items 17 and 20).
8.
Install adapter (Figure 2, Item 13) to hydraulic pump (Figure 2, Item 5).
9.
Connect suction hose (Figure 2, Item 12) to adapter (Figure 2, Item 13) and tighten clamp
(Figure 2, Item 11).
0059-4
03/15/2011Rel(1.10)root(maintwp)wpno(M1004826413)
