TM 5-3805-264-13&P
FIELD MAINTENANCE
HYDRAULIC PUMP REPAIR
INITIAL SETUP:
Tools and Special Tools
Materials/Parts (cont.)
Seal, Plain (Gasket) Qty: 2
General Mechanic's Tool Kit
(WP 0113, Table 1, Item 12)
(WP 0114, Table 1, Item 11)
Seal, Plain Encased (Lip Seal)
Machinist's Vise (WP 0113, Table 1, Item 14)
Socket Wrench Set: 3/4 in. drive
(WP 0114, Table 1, Item 10)
(WP 0113, Table 1, Item 10)
Rag, Wiping (WP 0112, Table 1, Item 29)
Torque Wrench, 3/4 in. drive, 0600 ft-lb
Ring, Retaining (WP 0114, Table 1, Item 29)
(0813 Nm) (WP 0113, Table 1, Item 17)
Valve, Check (Check Assembly) Qty: 2
(WP 0114, Table 1, Item 17)
Materials/Parts
Bearing, Roller Qty: 2
References
(WP 0114, Table 1, Item 9)
Gasket (Ring Seal) Qty: 2
(WP 0114, Table 1, Item 8)
Equipment Condition
Grease, Ball Bearing (WP 0112, Table 1, Item 12)
Hydraulic pump removed (WP 0059)
Lubricating Oil (WP 0112, Table 1, Item 23)
Seal, Nonmetallic (Pocket Seal) Qty: 12
(WP 0114, Table 1, Item 15)
WARNING
Use extreme care when handling heavy parts. Lifting cables, chains, hooks, and
slings must be in good condition and of suitable capacity. Keep clear of parts
supported only by lifting device.
Eye protection must be worn when removing or installing snap rings or retaining
rings.
Failure to comply may result in personnel injury, death, and/or damage to
equipment.
CAUTION
Remove dirt from outside of hydraulic pump. Perform repair in a clean work area to prevent
contaminants from causing equipment failure. Failure to comply may result in damage to
equipment.
NOTE
Mark castings of pump to aid in assembly.
0060-1
03/15/2011Rel(1.10)root(maintwp)wpno(M1004926413)