TM 5-3805-264-14&P
4-41.
MARKER CLEARANCE LIGHT REPLACEMENT.
This task covers:
a. Removal
b. Installation
Initial Setup.
Equipment Conditions:
• Batteries disconnected (TM 9-2320-363-20).
Tools/Test Equipment:
• General mechanic’s tool kit (Item 8, Appendix I)
NOTE
There is a marker clearance light on each side of dump body and a cluster of three
marker clearance lights on bracket at rear hinge. Replacement of a dump body
marker clearance light is shown.
a.
REMOVAL
1.
Remove marker clearance light (1) from grommet (2).
2.
Disconnect lights wiring harness connector (3) from back of marker clearance light (1). Remove marker
clearance light.
3.
Remove grommet (2) from dump body (4).
b. INSTALLATION
1.
install grommet (2) in dump body (4).
2.
Connect lights wiring harness connector (3) to back of marker clearance light (1).
3.
Install marker clearance light (1) in grommet (2).
FOLLOW-ON TASKS:
•
Connect batteries (TM 9-2320-363-20).
•
Check operation of marker clearance lights (TM 9-2320-363-10).
4-38
