TM 5-3805-264-14&P
4-62.
CAB SHIELD REPLACEMENT.
This task covers:
a. Removal
b. Cleaning and Inspection
c. lnstallation
Initial Setup:
Equipment Conditions:
l Beacon warning light removed (TM 9-2320-363-
10).
l Dump body raised and supported on body props
(paragraph 2-15).
l Beacon warning light wiring harness removed
from cab shield (paragraph 4-45).
Materials/Parts:
l Fourteen locknuts
Tools/Test Equipment:
l General mechanic’s tool kit (Item 8, Appendix I)
l Lifting slings (three) (Item 6, Appendix I)
l Torque wrench (Item 11, Appendix I)
l Suitable lifting device
Personnel Required: Three
General Safety Instructions:
l Use extreme caution when handling heavy parts.
a.
REMOVAL
1.
At center of cab shield (1), remove six locknuts (9), 12 washers (8), and six screws (7). Discard locknuts.
2.
Remove body props and lower dump body (paragraph 2-15).
4-94
