TM 5-3805-264-14&P
4-62.
CAB SHIELD REPLACEMENT (Con't).
Use extreme caution when handling heavy parts. Keep clear of heavy parts sup-
ported only by lifting device. Failure to follow this warning may cause death or
injury to personnel or damage to equipment.
3.
Attach lifting slings (2) to cab shield (1) and remove slack from lifting slings.
4.
Remove six locknuts (9), 12 washers (8), and six screws (7) from outside edges of cab shield (1) and dump
body (6). Discard locknuts.
5.
Remove two locknuts (5) four washers (4), and two screws (3) from top of cab shield (1) and dump body
(6). Discard locknuts.
6.
Lift cab shield (1) from dump body (6) and place cab shield in a safe work area
b.
CLEANING AND INSPECTION
Clean and inspect components in accordance with Chapter 4, Section Ill, General Maintenance Instruc-
tions.
1.
2.
3.
4.
5.
6.
Use extreme caution when handling heavy parts. Keep clear of heavy parts sup-
ported only by lifting device. Failure to follow this warning may cause death or
injury to personnel or damage to equipment.
Raise cab shield (1) to dump body (6).
Install two screws (3), four washers (4), and two new locknuts (5) to top of cab shield (1) and dump body
(6).
Install six screws (7), 12 washers (8), and six new locknuts (9) to outside edges of cab shield (1) and dump
body (6).
Remove lifting slings (2) from cab shield (1).
Raise and support dump body on body props (paragraph 2-15).
Install six screws (7) 12 washers (8), and six new locknuts (9) to center of cab shield (1) and dump body
(6).
4-95
