TM 5-3805-264-14&P
5-6.
HYDRAULIC CYLINDER REPLACEMENT (Con’t).
Clean and inspect components in accordance with Chapter 4, Section III, General Maintenance Instruc-
tions.
1.
2.
3.
4.
5.
6.
7.
Use extreme caution when handling
heavy parts. Keep clear of heavy
parts supported only by lifting
device. Failure to follow this warn-
ing may cause death or injury to
personnel or damage to equipment.
Install lifting sling through loop in hydraulic cyl-
inder (1) and attach lifting sling to lifting device.
Position hydraulic cylinder (1) to vehicle.
While holding hydraulic cylinder (1) securely,
position left and right mounting brackets (3 and
11) to hydraulic cylinder (1).
Install left and right mounting brackets (3 and
11) to dump body (12) with six screws (4) and
new locknuts (2).
Install lower end of hydraulic cylinder (1) to cyl-
inder support frame (7) with pivot pin (9), screw
(10), and new locknut (8).
Remove lifting sling from lifting device and
hydraulic cylinder (1).
Install two elbows (5) to lower end of hydraulic
cylinder (1). Connect two hose assemblies (6)
to elbows.
FOLLOW-ON TASKS:
Fill hydraulic reservoir (Chapter 3, Section I).
Remove body props and lower dump body (paragraph 2-15).
Install cab shield (paragraph 4-62).
5-22
