TM 5-3805-264-14&P
5-7.
HYDRAULIC CYLINDER REPAIR (Con’t).
NOTE
Hydraulic cylinder may be posi-
tioned horizontally and tipped to
extend sleeve. Wiper retainer and
seal should come out as sleeve is
extended a few inches. If not, apply
a three-inch strip of tape at a 45
degree angle to a cleaned section of
sleeve. Retract and again extend
sleeve to remove wiper retainer and
seal.
12.
Extend sleeve (3) to expose wiper retainer (16)
and seal (17). Remove wiper retainer and seal
from sleeve. Remove wiper (15) from wiper
retainer. Discard wiper, wiper retainer, and
seal. Remove tape from sleeve, if used.
13.
Retract sleeve (3). Remove spiral retaining
ring (18) from sleeve (14). Discard spiral
retaining ring.
14.
Extend sleeve (3) a few inches and apply tape
to a cleaned section of sleeve.
15.
Retract and extend sleeve (3) to expose bot-
tom guide ring (19). Remove and discard bot-
tom guide ring.
5-27
