TM 5-3805-264-14&P
5-7.
HYDRAULIC CYLINDER REPAIR (Con’t).
NOTE
20.
Wiper retainer and seal should
come out as sleeve is extended a
few inches. If not, apply a three-inch
strip of tape at a 45 degree angle to
a cleaned section of sleeve. Retract
and again extend sleeve to remove
wiper retainer and seal.
Extend sleeve (14) to expose wiper retainer
(27) and seal (28). Remove wiper retainer and
seal from sleeve. Remove wiper (26) from
wiper retainer. Discard wiper, wiper retainer,
and seal. Remove tape from sleeve, if used.
21.
Retract sleeve (14). Remove spiral retaining
ring (29) from barrel (25). Discard spiral retain-
ing ring.
22.
23.
Extend sleeve (14) a few inches and apply
tape to a cleaned section of sleeve.
Retract and extend sleeve (14) to expose bot-
tom guide ring (30). Remove and discard bot-
tom guide ring.
5-29
