TM 5-3805-274-13&P
0040
INSTALLATION - CONTINUED
NOTE
All fittings except for type I fittings used on hydraulic pump are
type II fittings as shown in Figure 1.
2. If elbow fitting (Figure 1, Item 7) is removed, install new O-ring (Figure 1, Item 5) and elbow fitting
(Figure 1, Item 7) and tighten nut (Figure 1, Item 6).
3. Install hose connector (Figure 1, Item 9) on elbow fitting (Figure 1, Item 7) and tighten swivel nut
(Figure 1, Item 8).
4. Start engine and engage PTO (TM 9-2320-273-10). Check system for oil leaks, raise dump body bed and
lower safety strut to stowed position, lower dump body bed (WP 0008). Shut down engine
(TM 9-2320-273-10).
TYPE II
TYPE I
1
1
2
10
9
3
8
4
5
6
7
Figure 1. Type I and Type II Hydraulic Lines, Fittings, and Hoses Removal and Installation.
PILOT
HYDRAULIC
HOIST
FILTER
RELIEF
PUMP
CYLINDER
ASSEMBLY
VALVE
HYDRAULIC
RESERVOIR
CONTROL
VALVE
Figure 2. Hydraulic Line and Hose Routing.
END OF TASK
END OF WORK PACKAGE
0040-3/4 blank