TM 5-3805-254-20-1
ORGANIZATIONAL TROUBLESHOOTING - CONTINUED
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
b. If two 52 wires (8 and 9) or 52A wire (10) are corroded, unscrew and take off nut
(11) and two 52 wires (8 and 9) and 52A wire (10), using 3/8-inch open-end
wrench. Using wire brush, clean wire terminals (12, 13, and 14). Place wire
terminals (12, 13, and 14) in position and screw nut on to terminal (15) and
tighten using 3/8-inch open-end wrench.
c. If two 52 wires (8 and 9) or 52A wire (10) is frayed, repair (page 2-424).
d. If two 52 wires (8 and 9) or 52A wire (10) is broken, two 52 wires (8 and 9) or 52A
wire (10) must be replaced. Notify Direct Support Maintenance.
e. If two 52 wires (8 and 9) or 52A wire (10) are not, loose, corroded, frayed, or broken,
go to step 26.
2-189
