TM 5-3805-254-20-1
FUEL PUMP FUEL FILTER - CONTINUED
INITIAL SETUP:
Equipment Condition
References
Left hood panel opened (page 2-424).
TM 9-247 (Authorized Cleaning Methods)
Battery cables disconnected (page 2-424).
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
WARNING
Diesel fuel burns easily. Do not smoke or allow flames nearby. Disconnect batteries when
working on fuel system. Failure to observe these precautions could cause serious injury or death
to personnel.
1.
Top of fuel
Filter cap (2)
Using 1/2-inch, 112-inch drive, flat-tip
pump (1)
screwdriver bit and ratchet handle, unscrew
and take off.
2.
Filter cap (2)
Cap seal (3)
a.
Take off.
b.
Get rid of.
3.
Top of fuel
Spring (4) and
Take out.
pump (1)
magnetic filter (5)
CLEANING
WARNING
Improper cleaning methods and use of unauthorized cleaning liquids or solvents can injure
personnel and cause damage to equipment. Refer to TM 9-247.
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Wear protective safety goggles and gloves
and use only in a well-ventilated area. Avoid contact with skin, eyes, and clothes and do not
breathe vapors. Do not use near open flame or excessive heat. The flashpoint for type #1
drycleaning solvent is 100°F (38°C) and for type #2 is 138°F (59°C). If you become dizzy while
using cleaning solvent, get fresh air immediately, and get medical aid. If contact with eyes is
made, flush your eyes with water and get medical aid immediately.
NOTE
For more information on how to clean parts, go to General Maintenance Instructions (page 2-424).
2-478
