TM 5-3805-254-20-1
EXHAUST DIVERTER
This task covers:
a.
Removal (page 2-600)
c.
Inspection/Replacement (page 2-602)
b.
Cleaning (page 2-601)
d.
Installation (page 2-602)
INITIAL SETUP:
Tools
Personnel Required
Brush, wire
Two
Gloves, safety
Goggles, safety
Equipment Condition
Wrench, box-end, 9/16-inch
Wrench, box-end, 3/4-inch (two
Exhaust pipe removed (page 2-590).
required)
Dump body raised and secured (page 2-424).
Materials/Parts
Rags, wiping (item 15, appendix C)
Solvent, dry-cleaning (item 19, appendix C)
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
WARNING
Exhaust system parts become very hot when engine is running. Allow time for parts to
cool before working on exhaust system. Hot exhaust system parts will cause serious
burns.
Edges of exhaust system components are sharp. Care must be taken to prevent personal
injury.
1.
Loop clamp (1) and
Two nuts (3) and two
Using 9/16-inch box-end wrench, unscrew
upper support (2)
flat washers (4)
and take off.
2.
Muffler (5)
Loop clamp (1) and
Take off.
saddle (6)
3.
Exhaust diverter (7)
Four locknuts (8),
a.
Using 3/4-inch box-end wrench, un-
exhaust shield plate
screw and take off locknuts.
(9), and four
b.
Lift off exhaust shield plate and
springs (10).
springs.
2-600
