TM 5-3805-254-20-2
WET AIR RESERVOIR
This task covers:
a.
Removal (page 2-986)
d.
Inspection/Replacement (page 2-990)
b.
Disassembly (page 2-988)
e.
Assembly (page 2-991)
c.
Cleaning (page 2-988)
f.
Installation (page 2-994)
INITIAL SETUP:
Tools
Materials/Parts
Brush, wire
Locknut, clamp (two required)
Flashlight
Rags, wiping (item 15, appendix C)
Gloves, safety
Solvent, drycleaning (item 19, appendix C)
Goggles, safety
Tape, antiseizing (item 22, appendix C)
Punch, pin, 1/4-inch
Tags, marker (item 21, appendix C)
Wrench, box-end, 9/16-inch (two
required)
Personnel Required
Wrench, open-end, 3/8-inch
Wrench, open-end, 9116-inch
Two
Wrench, open-end, 5/8-inch
Wrench, open-end, 11/16-inch
References
Wrench, open-end, 3/4-inch (two
required)
TM 43-0139 (Painting Instructions for Army
Wrench, open-end, 13/16-inch
Materiel)
Wrench, open-end, 7/8-inch
Wrench, open-end, 1-inch
Wrench, open-end, 11/8-inch
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
WARNING
Drain air from airbrake system before removing lines or fittings to avoid injury to personnel from
compressed air.
1.
Wet air
Automatic drain
Using 1/4-inch pin punch, push in on
reservoir (1)
valve (2)
manual drain pin (3) and allow compressed
air to drain.
NOTE
For more information on how to tag parts, go to General Maintenance Instructions (page 2-424).
Change 1 2-986
