TM 5-3805-254-20-2 DRY AIR RESERVOIR - CONTINUED ACTION LOCATION ITEM REMARKS INSTALLATION WARNING Due to excessive weight and size, assistance will be needed when handling dry air reservoir.  Failure to observe this precaution could cause injury to personnel. CAUTION Care must be taken not to drop dry air reservoir.  Damage to fittings or draincocks could occur. 43. Bracket (1) Dry air With assistance, put on. reservoir (2) 44. Two cable Put over dry air reservoir (2) and through assemblies (3) bracket. 45. Two cable Two nuts (4), two Screw on and tighten using 9/16-inch, 112- assemblies (3) new lockwashers (5), inch drive deep socket, 6inch extension, and two flat and ratchet handle. washers (6) 46. Dry air 90-degree elbow (7) Wrap pipe threads with antiseizing tape. reservoir (2) 47. 90-degree elbow (7) Airhose to wet air a. Screw on and tighten using 7/8-inch reservoir rear (8)open-end wrench. b. Take off tag. c. Get rid of tag. 48. Dry air 90-degree elbow (9) Wrap pipe threads with antiseizing tape. reservoir (2) 49. 90-degree elbow (9) Airhose to wet air a. Screw on and tighten using 7/8-inch reservoir front (10) open-end wrench. b. Take off tag. c. Get rid of tag. 50. Dry air 90-degree elbow (11) Wrap pipe threads with antiseizing tape. reservoir (2) 51. 90-degree elbow (11) Airhose to relay a. Screw on and tighten using 1 1/4-inch valve (12) open-end wrench. b. Take off tag. c. Get rid of tag. 2-984