TM 5-3805-254-20-2
CAB FLOOR THROUGH CONNECTOR TO DOUBLE CHECK VALVE HOSE - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
NOTE
Step 3 is typical for three clamp assemblies.
3.
Airhose (1)
Clamp (2),
a.
Using 7/16-inch box-end and 7/16-nch
screw (3),
open-end wrenches, unscrew and take
lockwasher (4),
out.
and nut (5)
b.
Get rid of lockwasher.
c.
Take clamp off airhose.
d.
Take out airhose.
4.
Driver’s seat
Line nut (7) and
a.
Using 9/16-inch open-end wrench, un-
valve assembly (6)
air line (8)
screw and take off.
b.
Move air line out of way.
5.
Left side rear
Eight screws (10),
a.
Using number two cross-tip screw-
cab wall (9)
eight flat washers
driver, unscrew and take out.
(11), and left
b.
Push air line (8) through hole while
lower rear
taking off left lower rear molding.
molding (12)
Be careful not to bend or crimp
air line.
6.
Cab floor through-
Line nut (14) and
a.
Using 5/8-inch open-end wrench, un-
connector 90-degree
air line (15)
screw and take off.
elbow (13)
b.
Move air line out of way.
7.
Cab floor through-
Using 9116-inch open-end wrench, un-
connector 90-degree
screw and take off.
elbow (13)
TA244400
2-1110
