TM 5-3805-254-20-2
REAR HUB AND BRAKEDRUM ASSEMBLY AND WHEEL BEARINGS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
28
New inner bearing
a
Position level and square.
cup (5)
b
Drive in until flush with top of rear hub
using wood block and 3-pound cross-
peen hammer.
c
Seat completely by tapping on alternate
sides using brass driftpin punch and 3-
pound cross-peen hammer.
Make sure inner bearing cup is flush
with machined surface inside rear
hub.
29
Outer bearing
a
Position brakedrum (2) on wood blocks
cup (6)
with axle flange studs (3) facing up.
b
Using puller, pull out.
c
Get rid of.
30
New outer bearing
a
Position level and square.
cup (6)
b
Drive in until flush with top of rear hub
using wood block and 3-pound cross-
peen hammer.
c
Seat completely by tapping on alternate
sides using brass driftpin punch and 3-
pound cross-peen hammer.
Make sure outer bearing cup is flush
with machined surface inside rear
hub.
TA244451
2-1197
