TM 5-3805-254-34
6-36.
TRANSMISSION OUTPUT SHAFT OIL SEAL REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Equipment Conditions:
Materials/Parts:
• Propeller shaft removed (see paragraph 7-1).
• Sealing compound (Item 19, Appendix B)
Tools/Test Equipment:
• One oil seal
• General mechanic's tool kit
• One packing retainer
• Field automotive shop set
a.
REMOVAL
Using slide hammer and remover, remove
packing retainer (3) and oil seal (2) from output
housing (1). Discard packing retainer and oil
seal.
b.
INSTALLATION
1.
Apply thin coat of sealing compound to outer surface of new oil seal (2).
2.
Install oil seal (2) with seal lip facing up.
3.
Apply thin coat of sealing compound to outer surface of new packing retainer (3).
4.
Install packing retainer (3), flat side first, in output housing (1).
5.
Press packing retainer (3) until flush with 0.04 in. (1.02 mm) below surface of output housing (1).
FOLLOW-ON TASKS:
• Install propeller shaft (see paragraph 7-1).
TA703887
6-172
