TM 5-3805-254-34
6-37.
OUTPUT HOUSING REPAIR.
This Task Covers:
a. Disassembly
c. Assembly
b. Cleaning and Inspection
Initial Setup:
Equipment Conditions:
Materials/Parts:
• Output housing removed (see paragraph 6-19).
• Hydraulic fluid (Item 7, Appendix B)
• Transmission output shaft oil seal removed (see
• Grease (item 10, Appendix B)
paragraph 6-36).
• Sealing compound (Item 19, Appendix B)
• Dry cleaning solvent (Item 23, Appendix B)
• Governor assembly removed (see paragraph 6-35).
• Two seals
General Safety Instructions:
Tools/Test Equipment:
• Dry cleaning solvent is flammable and must not be
• General mechanic's tool kit
used near open flame. Use only in a well-ventilated
• Field automotive shop set
area.
• Bar and stud
• Spring compressor
a.
DISASSEMBLY
1.
Remove snapring (1) from output housing (3).
2.
Remove output shaft (2) and retaining ring (4).
TA703888
6-173
