TM 5-3805-254-34
6-37.
OUTPUT HOUSING REPAIR (Con’t).
4.
Inspect dowel pins (14 and 15) for damage.
Replace if damaged. Dowel pins must extend
0.36-0.40 in. (9.14-10.16 mm).
5.
Inspect two pipe plugs (17) and plug (16) for
damage. Replace if damaged.
6.
Inspect bushing (19) in front of output shaft (2)
for wear or damage. Replace if damaged.
Clearance between main shaft (remaining in
transmission) and inside diameter of bushing
can be no greater than 0.004 in. (0.100 mm).
Install new bushing to depth of 0.145-0.165 in.
(3.683-4.191 mm).
7.
Inspect plug (18) for damage. Replace if
damaged.
8.
Inspect governor gear pin. If damaged, replace
governor gear pin.
c.
ASSEMBLY
1.
Apply thin coat of hydraulic fluid to surface of
new seals (12 and 13).
2.
With spring pins of clutch piston (11) facing
downward, install seals (12 and 13) to clutch
piston with lips of both seals facing upward.
TA703891
6-176
