TM 5-3805-254-34
6-38.
LOW PLANETARY CARRIER REPAIR.
This Task Covers:
a. Disassembly
c. Assembly
b. Cleaning and Inspection
Initial Setup:
Equipment Conditions:
Materials/Parts:
* Low planetary carrier removed (see paragraph 6-20).
•
Hydraulic fluid (Item 7, Appendix B)
Tools/Test Equipment:
• Dry cleaning solvent (Item 23, Appendix B)
• Four pinion pins
• General mechanic's tool kit
• Field automotive shop set
General Safety Instructions:
References:
* Dry cleaning solvent is flammable and must not
be
used near open flame. Use only in a well-ventilated
•·TM 9-214
area.
a.
DISASSEMBLY
1.
Remove ball bearing (1) from low planetary
carrier (2).
NOTE
Disassembly of low planetary carrier Is
required only If obvious wear or damage
Is evident.
2.
Using drill bit, center drill bit over one end of
each of four pinion pins (3).
3.
Drill downward into each pinion pin (3) until swaged end of each pinion pin is weakened for removal. Ensure that
metal of low planetary carrier (2) is not removed.
TA703894
6-179
