TM 5-3805-254-34
6-39.
ADAPTER HOUSING REPAIR (Con’t).
2.
Remove inner seal (6) and outer seal (7) from
first clutch piston (1). Discard seals.
CAUTION
Push-on nuts must be cut off when
removing.
Any
other
method
of
removing will lessen the holding power
of spring retainer during assembly.
3.
Cut four push-on nuts (3) off pins of first clutch
piston (1).
4.
Remove spring retainer (4) and 28 springs (5).
b.
CLEANING AND INSPECTION I
WARNING
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protective goggles and gloves, and
use only in a well-ventilated area. Avoid contact with skin, eyes, and clothes, and DO NOT breathe
vapors. DO NOT use near open flame or excessive heat. The solvent's flash point Is 100°F-138oF
(380C-590C). If you become dizzy while using cleaning solvent, Immediately get fresh air and medical
help. If solvent contacts eyes, Immediately wash your eyes and get medical aid.
1.
Clean metal parts with dry cleaning solvent.
2.
Inspect metal parts for cracks, breaks, wear, and other damage. Replace damaged parts.
3.
Inspect for broken or deformed springs. Springs must meet following requirements:
(a) Length without load:...........................................1.29 in. (3.28 cm mm).
(b) Length with load of 4.3-5.7 lb. (19.13-25.35 N): ..............0.82 in. (20.83 mm).
4.
Inspect dowel pins (8 and 9) in adapter housing
(2) for damage. Replace if damaged. Dowel
pins must extend 0.36-0.40 in. (9.14-10.16 mm).
5.
Inspect plug (10) in adapter housing (2).
Replace if damaged. Install plug flush with, or to
0.06 in. (1.52 mm) below front surface of
adapter housing.
TA703898
6-183
