TM 5-3805-254-34
9-5.
REAR-REAR DIFFERENTIAL MAINTENANCE (Con’t).
8.
Remove key (65) from cross-shaft (60).
9.
Remove two cross-shaft removal spacers (62)
from differential carrier (2).
10.
Cut lockwire and remove three screws (67) and
adjusting washer (66) from cross-shaft (60).
Discard lockwire.
11.
Press out ring gear set (61) and bearing (64) as
a unit, and remove from differential carrier (2).
Do not lose recessed washer (63).
12.
Remove recessed washer (63) if it did not come
loose during removal of ring gear set (61).
13.
If damaged, remove bearing (64) from ring gear
set (61).
e.
CLEANING AND INSPECTION }
WARNING
Dry cleaning solvent, P-D-680, Is toxic and flammable. Always wear protective goggles and
gloves, and use only In a well-ventilated area. Avoid contact with skin, eyes, and clothes, and DO
NOT breathe vapors. DO NOT use near open flame or excessive heat. The solvent’s flash point Is
100°F-1380F (380C-59°C). If you become dizzy while using cleaning solvent, Immediately get fresh
air and medical help. If solvent contacts eyes, Immediately wash your eyes and get medical aid.
1.
Clean all metal parts with dry cleaning solvent.
NOTE
If one differential case bearing needs to be replaced, replace both differential case bearings.
2.
Inspect bearings for damage (see TM 9-214).
TA703978
9-47
