TM 5-3805-254-34
17-1.
DUMP BODY HYDRAULIC LIFT CYLINDER REPLACEMENT (Con’t).
b. INSTALLATION
1.
Attach overhead lifting device to hydraulic cylinder (1).
WARNING
Ensure that all personnel are clear of hydraulic cylinder before raising to prevent Injury to
personnel.
2.
Raise hydraulic cylinder (1) and move to vehicle.
3.
Position lower end of hydraulic cylinder (1) to subframe (5).
4.
Apply coat of grease to cylinder base pin (4).
5.
Install cylinder base pin (4) and two new cotter pins (3) to secure hydraulic cylinder (1) to subframe (5).
6.
Rotate top of hydraulic cylinder (1), if necessary, so that screw (2) faces front of vehicle.
7.
Position top of hydraulic cylinder (1) against rear of vehicle cab and remove overhead lifting device.
FOLLOW-ON TASKS:
•
Connect valve-to-cylinder pressure hose and fitting (see TM 5-3805-254-20).
•
Install dump body (see paragraph 15-36).
17-3
