TM 5-3805-264-13&P
0066
DISASSEMBLY - Continued
NOTE
Perform Steps 11 through 18 to remove next sleeve.
11.
Remove retaining ring (Figure 7, Item 1) from sleeve (Figure 7, Item 2).
Figure 7. Retaining Ring Removal.
NOTE
Hydraulic cylinder may be positioned horizontally and tipped to extend sleeve. Wiper
retainer and seal should come out as sleeve is extended a few inches. If not, apply a three-
inch strip of tape at a 45 degree angle to a cleaned section of sleeve. Retract and again
extend sleeve to remove wiper retainer and seal.
12.
Extend sleeve (Figure 8, Item 1) to expose wiper retainer (Figure 8, Item 3) and seal (Figure 8, Item 4).
Remove wiper retainer and seal from sleeve. Remove wiper (Figure 8, Item 2) from wiper retainer. Discard
wiper, wiper retainer, and seal. Remove tape from sleeve, if used.
Figure 8. Wiper Component Removal.
03/15/2011Rel(1.10)root(maintwp)wpno(M1005126413)