TM 5-3805-264-13&P
0066
DISASSEMBLY - Continued
NOTE
Perform Steps 19 through 26 to remove next sleeve.
19.
Remove retaining ring (Figure 13, Item 1) from barrel (Figure 13, Item 2).
Figure 13. Retaining Ring Removal From Barrel.
NOTE
Wiper retainer and seal should come out as sleeve is extended a few inches. If not, apply a
three-inch strip of tape at a 45-degree angle to a cleaned section of sleeve. Retract and
again extend sleeve to remove wiper retainer and seal.
20.
Extend sleeve (Figure 14, Item 1) to expose wiper retainer (Figure 14, Item 3) and seal (Figure 14, Item 4).
Remove wiper retainer and seal from sleeve. Remove wiper (Figure 14, Item 2) from wiper retainer. Discard
wiper, wiper retainer, and seal. Remove tape from sleeve, if used.
Figure 14. Wiper, Wiper Retainer, and Seal Removal.
03/15/2011Rel(1.10)root(maintwp)wpno(M1005126413)