TM 5-3805-264-14&P
4-73.
HYDRAULIC RESERVOIR REPLACEMENT.
This task covers:
a. Removal
b. Cleaning and Inspection
c. Installation
Initial Setup:
Equipment Conditions:
Materials/Parts (Cont):
Dump body raised and supported on body props
(paragraph 2-l 5).
Hydraulic oil drained (Chapter 3, Section I).
Tools/Test Equipment:
General mechanics tool kit (Item 8, Appendix I)
Cap and plug set (Item 1, Appendix I)
Nylon sling (Item 6, Appendix I)
Adjustable wrench (Item 10, Appendix I)
Torque wrench (Item 11, Appendix I)
Suitable lifting device
Materials/Parts:
Antiseize tape (Item 20, Appendix F)
Four locknuts
Four lockwashers
Personnel Required: Two
General Safety instructions:
NEVER work under a raised dump body unless it
is secured in the raised position with body props
and dump body is EMPTY.
DO NOT disconnect hydraulic lines while engine
is running.
Rags (Item 15, Appendix F)
Use extreme caution when handling heavy parts.
NEVER work under a raised dump body unless it is secured in the raised posi-
tion with body props and dump body is EMPTY. Failure to follow this warning
may result in death or injury to personnel.
DO NOT disconnect hydraulic lines while engine is running. Engine must be
shut down and dump body fully lowered or supported on body props before
lines are disconnected. Escaping hydraulic fluid under pressure can penetrate
the skin, causing serious injury to personnel.
Hoses and ports in hydraulic components should be plugged to prevent contamina-
tion of hydraulic system (paragraph 4-21).
1.
NOTE
Hoses should be tagged before removal (paragraph 4-17).
Use a suitable container to catch any draining hydraulic fluid. Ensure that all
spills are cleaned up.
Disconnect hydraulic return hose (4) from tee (2).
4-136
