TM 5-3805-264-14&P
4-73.
HYDRAULIC RESERVOIR REPLACEMENT (Con’t).
1.
2.
3.
4.
5.
6.
7.
Use extreme caution when handling heavy parts. Keep clear of heavy parts sup-
ported only by lifting device. Failure to follow this warning may cause injury to per-
sonnel or damage to equipment.
NOTE
Use antiseize tape on all pipe threads (paragraph 4-22).
Attach a nylon sling and suitable lifting device
to hydraulic reservoir (15). Take up slack in
sling.
Position hydraulic reservoir (15) on cylinder
support frame (14).
Install four screws (5) washers (6), new lock-
washers (7), spacers (8), and new locknuts (9).
Torque locknuts to 100-110 lb.-ft. (136-149
N•m). Remove nylon sling.
Install elbow (13) and hose barb (12) to
hydraulic reservoir (15).
Connect suction hose (11) to hose barb (12)
and tighten clamp (10).
Install tee (2) with oil sampling valve (3) to filter
housing (1).
Connect hydraulic return hose (4) to tee (2).
FOLLOW-ON TASKS:
Fill hydraulic reservoir (Chapter 3, Section I).
Remove body props and lower dump body (paragraph 2-15).
4-138
