TM 5-3805-254-20-1
ACCELERATOR CONTROL PIVOT ARM - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
NOTE
For more information on cotter pins, go to General Maintenance Instructions (page 2-424).
5.
Pedal bracket (1)
Cotter pin (2) and
a.
Using 6-inch diagonal-cutting pliers,
flat washer (3)
close ends of cotter pin and pull out.
b.
Take off flat washer.
c.
Get rid of cotter pin.
6.
Clevis pin (4) and
a.
Using 6-inch slip-joint pliers, pull out
control pedal (5)
clevis pin.
b.
Take out control pedal.
7.
Engine cover
Pivot arm assembly
a.
Using 7/16-inch, 1/2-inch drive sock-
side panel (6)
(7), two screws (8),
et, ratchet handle, and 7/16-inch
two lockwashers (9),
open-end wrench, unscrew and take
and two nuts (10)
out.
b.
Take out pivot arm assembly.
c.
Get rid of lockwashers.
CLEANING
WARNING
Improper cleaning methods and use of unauthorized cleaning liquids or solvents can injure
personnel and damage equipment. Refer to TM 9-247.
NOTE
For more information on how to clean parts, go to General Maintenance Instructions (page 2-424).
8.
Pivot arm
Clean thoroughly with liquid detergent.
assembly (7)
WARNING
Particles blown by compressed air are hazardous. Make certain the airstream is directed away
from user and other personnel in the area. Compressed air used for cleaning purposes shall not
exceed 30 psi (207 kPa). User must wear safety goggles or face shield to prevent injury to
personnel.
2-570
