TM 5-3805-254-20-1
ACCELERATOR CONTROL PIVOT ARM - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION
12.
Engine cover
Pivot arm assembly
a.
Put pivot arm assembly in place.
side panel (1)
(2), two screws (3),
b.
Screw on and tighten using 7/16-inch,
two new lockwashers
1/2-inch drive socket, ratchet handle,
(4), and two nuts (5)
and 7/16-inch open-end wrench.
13.
Pedal bracket (6)
Control pedal (7)
a.
Put control pedal in place.
and clevis pin (8)
b.
Put in clevis pin using 6-inch slip-joint
pliers.
NOTE
For more information on cotter pins, go to General Maintenance Instructions (page 2-424).
14.
Flat washer (9) and
a.
Put on flat washer.
new cotter pin (10)
b.
Put in cotter pin and bend back ends
using 6-inch diagonal-cutting pliers.
NOTE
Flat sides of pivot arm assembly must aline with slot on lever assembly.
2-572
