TM 5-3805-254-20-2
HYDRAULIC OIL RESERVOIR - CONTINUED
REMOVAL
1. Reservoir (1)
Valve (2)
Turn clockwise to close.
2. Hose (3)
Clamp (4)
a. Place 6-gallon container underneath.
b. Using 1/4-inch flat-tip screwdriver,
unscrew and take off.
3. Nipple (5)
Hose (3)
a. Take off.
b. Allow oil to drain.
4. Reservoir (1)
Valve (2)
a. Place 6-gallon container underneath.
b. Slowly turn counterclockwise to open.
c. Allow oil to drain.
5. Union (6)
Hose (7)
a. Place 6-gallon container underneath.
b. Using 1 3/8-inch and 1 112-inch open-
end wrenches, unscrew and take out.
c. Allow oil to drain.
6. Filter housing (8)
Drainplug (9)
a. Place 6-gallon container underneath.
b. Using 7/16-inch open-end wrench, un-
screw and take out.
c. Allow oil to drain.
NOTE
Assistance will be needed to perform steps 7 and 8.
7. Two straps (10) and
Two nuts (11) and
a. Using 20-ton hydraulic floor jack, have
eservoir (1)
two lockwashers (12)
two assistants hold reservoir.
b. Using 15/16-inch open-end wrench,
unscrew and take off.
c. Get rid of lockwashers.
CAUTION
Use care when removing reservoir and fittings, damage could occur.
8. Two straps (10)
Reservoir (1)
With assistance, using 20-ton hydraulic
floor jack, take down and out.
2-1376
