TM 5-3805-254-20-1
ACCELERATOR CONTROL PEDAL - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ADJUSTMENT
NOTE
If locknut on bolt is tight, perform step 13.
13.
Floor panel (1)
Control pedal (2),
a.
Lift control pedal.
bolt (3), and
b.
Using 1/2-inch open-end wrench,
locknut (4)
loosen locknut.
c.
Turn locknut to end of threads.
14.
Bolt (3) and
Turn bolt down until locknut touches floor
locknut (4)
panel.
NOTE
Assistance will be needed to perform the following steps.
Top of throttle lever will pivot when pushed past full throttle position.
15.
Fuel pump (5)
Throttle lever (6)
a.
Have assistant push throttle lever to full
throttle position.
b.
Push throttle lever past full throttle
position until top of throttle lever pivots
slightly, and hold in position.
NOTE
When performing next step control pedal (2) must contact pivot arm assembly (7).
16.
Floor panel (1)
Bolt (3)
Turn until head of bolt touches control
pedal (2).
17.
Fuel pump (5)
Throttle lever (6)
Have assistant release throttle lever.
18.
Floor panel (1)
Bolt (3) and
a.
Hold bolt in position.
locknut (4)
b.
Tighten locknut using 1/2-inch open-
end wrench.
2-578
