TM 5-3805-264-14&P
5-1.
DUMP BODY AND STABILIZER REPLACEMENT (Con't).
6.
Using suitable lift and chains, lower front of dump body (4).
7.
Attach suitable lift and chains at four corners of dump body (4). Take up slack in chains with lift.
8.
Remove two locknuts (18) and screws (17) from rear hinge (15) and hinge pins (19). Discard locknuts
9.
Remove left and right hinge pins (19) from rear hinge (15).
Use extreme caution when handling heavy parts. Keep clear of heavy parts sup-
ported only by lifting device. Failure to follow this warning may cause death or
injury to personnel or damage to equipment.
NOTE
Before removing dump body from vehicle chassis, perform a trial lift to ensure body
is balanced and will lift straight and level from vehicle chassis.
10.
Remove dump body (4) from vehicle chassis (7). Place dump body on suitable supports and remove lifting
device and chains.
Before welding, the following components must be disconnected: DDEC ECU, ABS
ECU, CTIS ECU, Datalogger, and batteries (TM 9-2320-363-20). Failure to follow this
caution may damage electronic components.
11.
If stabilizer is damaged, it may be removed at this time (TM 9-237)
5-3
