TM 5-3805-264-14&P
5-1.
DUMP BODY AND STABILIZER REPLACEMENT (Con't).
5.
Install left and right hinge pins (19) in rear hinge (15).
6.
Install two screws (17) and new locknuts (18) in rear hinge (15) and hinge pins (19).
7.
Lower dump body (4) onto vehicle chassis (7). Remove lifting chains from rear of dump body.
8.
Working from underside of vehicle, release lower half (6) and upper half (5) of stabilizer from bottom of
dump body (4).
NOTE
It may be necessary to raise front of dump body to aline stabilizer with chassis
mounting holes.
9.
Raise front of dump body (4) and position wooden blocks between dump body frame rails (8) and vehicle
chassis (7).
10.
Aline lower half of stabilizer mounting surface
to angle brackets (3). Install six screws (1) and
new locknuts (2) in left and right angle brack-
ets. Torque locknuts to 150 lb.-ft. (203 N•m).
11.
Lift front of dump body (4) remove wooden
blocks, position body props in raised position,
and lower body onto props (paragraph 2-15).
5-5
