TRUCK SERVICE MANUAL
TRANSMISSIONS
Para 5-10 5-12
HT 700D SERIES TRANSMISSIONS
Fig. 5-37 Removing second-clutch snapring
5-12. REMOVING REAR COMPONENTS
a. Rear Cover
Fig. 5-37 Removing second-clutch snapring
(1) Invert the transmission housing, rear cover
upward. Remove the twenty-four bolts and washers that
retain the rear cover and the adapter housing to the
transmission
(2) Attach a hoist to the lifting bracket (fastened to
output shaft) and carefully separate the rear cover from
the adapter housing (fig. 5-41). Remove the rear cover
gasket.
(3) Refer to paragraph 6-22 for rebuild of the rear
cover assembly.
b. Low Planetary and Clutch
(1) Remove the low planetary carrier assembly (fig.
5-42).
NOTE
Because the bearing fit on the carrier hub may not be
tight, do not attempt to carry the planetary carrier by the
bearing.
Fig. 5-3-4 Removing center support snapring
732