TM 5-3805-264-14&P
4-45.
BEACON WARNING LIGHT WIRING HARNESS MAINTENANCE (Con’t).
b.
REPAIR
NOTE
Wiring harness need not be removed from vehicle to make repairs.
Repair wiring harness in accordance with instructions in Chapter 4, Section III, General Maintenance
Instructions.
c.
INSTALLATION
1.
2.
3.
4
5.
6.
Install wiring harness (3) through cab shield grommet (1).
7.
Connect two wiring harness connectors to beacon warning light connectors.
8.
Install new tie wraps.
Position wiring harness (3) between points of connection.
Connect wiring harness connector (11) to chassis wiring harness connector (10).
Route wiring harness (3) along inner surface of right side dump body frame rail (8) and through grommet
(7) at front of right side dump body (9).
Route wiring harness (3) up dump body (9) and cab shield (2) Secure with clamps (5) and new locknuts (4)
on welded studs (6).
Secure wiring harness (3) along inner surface of right side dump body frame rail (8) with clamps (5) and
new locknuts (4)on welded studs (6).
FOLLOW-ON TASKS:
•
Connect batteries (TM 9-2320-363-20).
•
Remove body props and lower dump body (paragraph 2-15).
•
Check operation of beacon warning light (TM 9-2320-363-10).
4-51
